📞 Contact UsHomeProductsCatalogueApplicationsProjectsMarketsBlog🎬 VideosTools💰 CalculatorAbout
FRP Pultruded Profiles

FRP Square Rod — Pultruded Square Bar

A solid square section, used where a flat face and a straight edge are more useful than a circle: frames, spacers, inserts, and small members that need to sit square against something.

What it is

Square rod is a solid pultruded bar with four flat faces. Compared with a round rod of the same cross-sectional area it is stiffer about its two axes and weaker across the diagonal, but it has something a circle does not: faces that sit flat, corners that locate, and an edge that can be clamped without a special fixture.

Where it is used

  • Small frames and spacers where the member has to sit square against a panel or a plate.
  • Inserts and locating blocks in FRP assemblies, where a flat face bears on the part beside it.
  • Grill and infill bars on screens and guards.
  • Support blocks under equipment where a corrosion-free pad is wanted.
  • Machined parts turned from square stock, where the flat faces make clamping easy.

Behaviour

Bending about a face axis follows the same arithmetic as a flat bar: section modulus is side cubed over six, and the second moment of area is side to the fourth over twelve. Loaded across the diagonal, the section is weaker, and the failure starts at the corners where the stress concentrates.

Bearing is the other consideration. A square rod used as a support block spreads load across a flat face, which is exactly what a round rod cannot do, and that is often the reason it is chosen over a cheaper round section.

Detail notes

Where a square rod is used as a locating insert, the fit matters more than the strength. Pultruded stock has a tolerance on the side dimension, and a tight fit into a moulded pocket needs the stock to be machined rather than used as pultruded.

Cut ends should be sealed where exposed, and where the rod sits in a joint that will be wet, the sealing is not optional.

Specifying an FRP square rod

  • Side dimension, length and tolerance, stated as pultruded stock or machined.
  • Grade to BS EN 13706 where the bar carries load.
  • Resin and colour, particularly where the part is visible.
  • Whether the ends need sealing or machining.
  • Any requirement on the corner radius, since square stock has slightly rounded corners as pultruded.

Related pages

FAQ

What is FRP square rod used for?
Spacers, locating blocks, small frames, infill bars and machined parts that need flat faces to sit against something.
Is square rod stronger than round rod?
About its own axes, yes for the same cross-sectional area. Across the diagonal it is weaker, and the corners are where failure starts.
Can square rod be used as a beam?
Over short spans with light loads, and with the load applied about a face axis rather than the diagonal.
Are the corners of pultruded square rod sharp?
Slightly rounded, as pultruded stock comes out of a die. Where a sharp corner is needed, the part is machined.
What tolerance does pultruded square rod hold?
A commercial pultrusion tolerance on the side dimension. Tight fits call for machining rather than stock.
Do cut ends need sealing?
Yes where exposed to weather or chemicals, to keep moisture out of the cut face.

Document Preview

Preview mode · For full document, click Download

Download Document

Thank you for your interest. Please fill in your email and company name. Our technical and sales team will contact you within 30 minutes (during working hours) to provide support!

📧 Your information will be sent to [email protected]. We respect your privacy and will never share your data.

Thank You!

Your request has been received successfully.

Our technical and sales team will contact you within 30 minutes (during working hours) to provide the document and professional support!

If you need urgent assistance, please email: [email protected]