FRP Grating Specifications
65 mm HD Pultruded I-bar FRP/GRP Grating
Heavy-duty 65 mm pultruded I-bar FRP grating for long spans, heavy platforms and industrial traffic where a stiff one-directional deck is required.
Technical specifications
| Type | Pultruded I-bar FRP/GRP grating |
|---|---|
| Mesh opening | I-bar 65 mm HD |
| Thickness | 65 mm |
| Standard panel size | 1220 x 3660 mm (4 x 12 ft), cut to size |
| Open area | On request — confirm with factory |
| Unit weight | On request — confirm with factory |
| Resin systems | Isophthalic polyester; vinyl ester; phenolic on request |
| Surface options | Concave (meniscus) top, quartz-grit anti-slip, smooth |
Load and span guidance
| Support span | Allowable UDL (kN/m²) |
|---|---|
| 600 mm | 62 kN/m² |
| 900 mm | 35 kN/m² |
| 1200 mm | 20 kN/m² |
Deflection basis: L/200, simply supported single span. Indicative allowable uniform load for preliminary sizing, deflection L/200, simply supported single span. Point, concentrated, cantilever and line-load cases are not covered by this table and must be checked separately. Load duration, temperature, chemical attack and impact all reduce the capacity a table figure can carry.
Typical applications
- Walkways and platforms
- Chemical and process plants
- Water and wastewater
- Trench and drain covers
Sizing, installation and procurement
The 65 mm HD I-bar section
The deep I-bar section carries load along the bar direction with high stiffness for long-span platforms, drum storage and trafficked decks. Bars are continuous rather than glued, which keeps alignment under repeated plant traffic.
65 mm depth, heavy load and long span
The 65 mm HD depth is the high-load option for wider supports and heavy plant. The allowable uniform load below is read at the real support span against L/200; pultruded strength follows the bar direction, so the deck must be oriented accordingly.
Resins and finishes for an HD deck
Isophthalic polyester for general service; vinyl ester for acids, alkalis and chlorides; phenolic on request for offshore and fire-critical decks. Concave or quartz-grit surface for ramps and public routes; smooth for hygienic wash-down areas.
Cutting and fixing the 65 mm HD section
Heavy-duty saddle and clip with stainless bolts; through-fixing at every bearer on exposed or trafficked decks. Per-bar and panel weight for this HD section are confirmed with the factory before quoting; cut edges should be sealed.
Manufactured in our own plant in Nantong under an ISO 9001 quality management system. An ASTM F3059 test report is available on request. Certificates and test reports are provided for the supplied product on request.
Technical data sheets (PDF)
Data sheets carry no certificate numbers; full test reports are sent on request.
