📞 Contact UsHomeProductsCatalogueApplicationsProjectsMarketsBlog🎬 VideosTools💰 CalculatorAbout

FRP Grating Specifications

38 mm Molded FRP/GRP Grating, 50 x 50 mm Mesh

38 mm molded FRP grating with a wider 50 x 50 mm mesh for high drainage and ventilation where small-object retention is not required.

Technical specifications

TypeMolded FRP/GRP grating
Mesh opening50 x 50 mm
Thickness38 mm
Standard panel size1220 x 3660 mm (4 x 12 ft), cut to size
Open areaOn request — confirm with factory
Unit weightOn request — confirm with factory
Resin systemsIsophthalic polyester; vinyl ester; phenolic on request
Surface optionsConcave (meniscus) top, quartz-grit anti-slip, smooth

Load and span guidance

Support spanAllowable UDL (kN/m²)
600 mm22 kN/m²
900 mm10 kN/m²
1200 mm5.5 kN/m²

Deflection basis: L/200, simply supported single span. Indicative allowable uniform load for preliminary sizing, deflection L/200, simply supported single span. Point, concentrated, cantilever and line-load cases are not covered by this table and must be checked separately. Load duration, temperature, chemical attack and impact all reduce the capacity a table figure can carry.

Typical applications

  • Walkways and platforms
  • Chemical and process plants
  • Water and wastewater
  • Trench and drain covers

Sizing, installation and procurement

The 50 x 50 mm open mesh

The 50 x 50 mm opening spreads a load over fewer bearing bars and lets water and vapour pass freely. It suits drainage ditches, ventilated decks and spill areas; it is not intended where tools, screws or heels must be retained.

38 mm depth, load and wider-mesh behaviour

The 38 mm depth carries the wider-mesh layout for process decks and open platforms. The allowable uniform load below is read at the real support span against L/200; because this mesh spreads loads differently, confirm the section against the project load case.

Resins and finishes for a drainage deck

Isophthalic polyester for general outdoor and moist service; vinyl ester for acids, alkalis and chlorides; phenolic on request for fire-critical areas. Concave, quartz-grit and smooth finishes are available per route and wash-down requirement.

Cutting and fixing the 38 mm 50 x 50 panel

Standard panel 1220 x 3660 mm, cut to drawing with deburred edges. M, C, L or Z clips with stainless bolts; corner through-bolting on exposed or trafficked decks. Weight and open area for this mesh are confirmed with the factory before quoting.

Manufactured in our own plant in Nantong under an ISO 9001 quality management system. An ASTM F3059 test report is available on request. Certificates and test reports are provided for the supplied product on request.

Technical data sheets (PDF)

Data sheets carry no certificate numbers; full test reports are sent on request.

Related resources

FAQ

Where is the 50 x 50 mm molded mesh used?

What load can a 38 mm 50 x 50 panel carry at 900 mm span?

Document Preview

Preview mode · For full document, click Download

Download Document

Thank you for your interest. Please fill in your email and company name. Our technical and sales team will contact you within 30 minutes (during working hours) to provide support!

📧 Your information will be sent to [email protected]. We respect your privacy and will never share your data.

Thank You!

Your request has been received successfully.

Our technical and sales team will contact you within 30 minutes (during working hours) to provide the document and professional support!

If you need urgent assistance, please email: [email protected]