FRP Grating Specifications
25 mm Molded FRP/GRP Grating, 38 x 38 mm Mesh
Lightweight 25 mm square-mesh molded FRP grating for general walkways where depth is limited and the load is moderate.
Technical specifications
| Type | Molded FRP/GRP grating |
|---|---|
| Mesh opening | 38 x 38 mm |
| Thickness | 25 mm |
| Standard panel size | 1220 x 3660 mm (4 x 12 ft), cut to size |
| Open area | 68% |
| Unit weight | 12.5 kg/m² |
| Resin systems | Isophthalic polyester; vinyl ester; phenolic on request |
| Surface options | Concave (meniscus) top, quartz-grit anti-slip, smooth |
Load and span guidance
| Support span | Allowable UDL (kN/m²) |
|---|---|
| 600 mm | 12.5 kN/m² |
| 900 mm | 6.0 kN/m² |
| 1200 mm | 3.2 kN/m² |
Deflection basis: L/200, simply supported single span. Indicative allowable uniform load for preliminary sizing, deflection L/200, simply supported single span. Point, concentrated, cantilever and line-load cases are not covered by this table and must be checked separately. Load duration, temperature, chemical attack and impact all reduce the capacity a table figure can carry.
Typical applications
- Walkways and platforms
- Chemical and process plants
- Water and wastewater
- Trench and drain covers
Sizing, installation and procurement
The 38 x 38 mm mesh and its real use
The 38 x 38 mm square opening balances drainage, safe footwear contact and bidirectional strength. It suits standard industrial footwear; smaller tools or screws that must not drop through call for a finer mesh.
25 mm depth, load and span
At 25 mm this section is the economical choice for short, lightly trafficked spans. The allowable uniform load below is read at the real support span against the L/200 deflection limit rather than chosen from thickness alone.
Resins and finishes for a light walkway
Isophthalic polyester covers general outdoor and moist service; vinyl ester is selected for acids, alkalis and chlorides; phenolic is available on request for fire-critical areas. The concave meniscus top grips when wet, the quartz-grit finish suits ramps and busy outdoor routes, and the smooth top eases wash-down.
Cutting and fixing the 25 mm panel
Standard panel 1220 x 3660 mm, cut to drawing with deburred edges. Fix with M, C, L or Z clips and stainless bolts; on exposed or trafficked decks add corner through-bolting. Minimum order 10 m²; standard lead time 12–36 working days.
Manufactured in our own plant in Nantong under an ISO 9001 quality management system. An ASTM F3059 test report is available on request. Certificates and test reports are provided for the supplied product on request.
Technical data sheets (PDF)
Data sheets carry no certificate numbers; full test reports are sent on request.
