FRP Round Tube — Pultruded Circular Hollow Section
A hollow circle: the only pultruded section that carries torsion properly, and the one that turns a slender member into a column. Used for handrail, posts, and any member loaded in more than one direction.
Why a tube, and not a rod
A tube puts the material at the outside of the section, where it does the most work in bending and in torsion, and removes the core that does almost nothing. For the same mass, a tube is far stiffer than a rod. For the same diameter, a tube is lighter and slightly less stiff, which is the trade a handrail or a post makes every day.
The closed section is the real advantage. A round tube resists torsion that an open channel or angle simply cannot, which is why it is the default shape for anything a person grabs, leans on or twists.
Where round tube appears on a grating project
- Handrail top and mid rails, commonly 40 or 50 mm outside diameter, on FRP handrail systems.
- Handrail posts and infill, where the tube is loaded in bending and in torsion at once.
- Ladder stiles and rails on FRP ladders.
- Struts and compression members in frames, where the closed section resists buckling.
- Guard rails around openings, and rails that double as the edge protection on a roof walkway.
Behaviour
Bending stiffness follows the second moment of area, which for a thin-walled tube is close to pi times diameter cubed times wall thickness divided by eight. Torsion follows the polar second moment, roughly double that, and a closed section delivers it.
In compression a tube behaves as a column: the capacity falls with the square of the effective length, and the wall thickness decides whether it fails by buckling or by crushing. A tube with a thin wall over a large diameter is efficient until the wall buckles locally, which is why very slender FRP tubes are not specified as columns without a check.
Detail notes
Handrail posts are the connection that matters. A post is typically a square tube for the base connection, or a round tube bolted through a base plate; a round post bolted straight through its curved wall concentrates load on two small contact patches and crushes the wall unless a sleeve or a plate is used.
Where tubes are joined end to end, the joint is usually a sleeve or an internal insert plus bolts. A bare butt joint between two tubes has almost no bending capacity even if it looks continuous.
Specifying an FRP round tube
- Outside diameter, wall thickness, and the length or cut list.
- Grade to BS EN 13706, E17 or E23, where the tube is structural.
- Resin and colour, and the surface finish for a rail that will be grabbed.
- Whether the tube is used as a rail, a post or a compression member, because the detail changes with the duty.
- Base and joint details if the tube is part of a handrail system, so that the post, plate and bolt arrive together.
Related pages
- FRP handrail systems
- GRP structural profiles overview
- FRP square tube
- All FRP profiles
- FRP ladder
- Rooftop safety and edge protection
