📞 Contact UsHomeProductsCatalogueApplicationsProjectsMarketsBlog🎬 VideosTools💰 CalculatorAbout
FRP Grating Specifications

76 mm I-Bar Pultruded FRP Grating

The deepest standard pultruded section: four and a half metres and beyond, where a steel deck would need extra beams or a crane.

Technical specifications

TypePultruded FRP grating, I-bar section, extra deep bar
Bearing bar depth76 mm (3 in)
SectionI profile with top and bottom flange
Bar pitch38 mm standard
Open areaabout 50% (clear 19 mm) or about 60% (clear 23 mm)
Unit weightabout 26 kg/m² at 50% open; about 23 kg/m² at 60% open
Standard panel1220 x 3660 mm; 6000 mm on request; cut to size
Resin systemsIsophthalic polyester; vinyl ester; phenolic
SurfaceConcave or grit; grit recommended on any sloped deck
FixingHeavy-duty saddle, SS316 bolts, end and intermediate fixings per load table

Load and span guidance

Support spanIndicative UDL, 50% openIndicative UDL, 60% openDeflection basis
3.0 mabout 780 kg/m²about 680 kg/m²L/200
3.5 mabout 565 kg/m²about 490 kg/m²L/200
4.0 mabout 425 kg/m²about 370 kg/m²L/200
4.5 mabout 330 kg/m²about 285 kg/m²L/200

Indicative values for a single simply supported span under uniform load. At this depth the deck is normally used where the span cannot be reduced, and the deflection limit is the design driver. Certified values, including wind and snow combinations, are supplied with the quotation.

Sizing a very long span honestly

At 76 mm the section is stiff enough for four and a half metres at foot-traffic load, and it is the point at which a pultruded deck starts to compete directly with a steel grating on span rather than only on corrosion. It is also heavy at 23 to 26 kg/m², so the conversation moves to how the panel is lifted and how the supports are fixed rather than only to load capacity.

We do not recommend this section for spans beyond about five metres without an engineered check, and we will not present a five-metre deck as routine. Where the geometry really demands it, an intermediate bearer or a trussed support is usually cheaper and more honest than a deeper composite bar, and we say so before the quotation is issued rather than after the deck has been ordered.

Where it fits

  • Long quay and jetty walkways between mooring points
  • Cable and pipe bridges crossing wide service corridors
  • Cooling tower and chimney access decks
  • Large roof spans on industrial buildings with limited supports
  • Replacement of long steel grating runs in corrosive service

A 76 mm panel of 6 m weighs around 190 kg, so mechanical lifting with spreader beams is required. The bearers should be checked for level and the panels laid with a small expansion gap at each end of a long run.

Related resources

FAQ

W
A
I
Y
H
A
W
A
C
I
D
O

Document Preview

Preview mode · For full document, click Download

Download Document

Thank you for your interest. Please fill in your email and company name. Our technical and sales team will contact you within 30 minutes (during working hours) to provide support!

📧 Your information will be sent to [email protected]. We respect your privacy and will never share your data.

Thank You!

Your request has been received successfully.

Our technical and sales team will contact you within 30 minutes (during working hours) to provide the document and professional support!

If you need urgent assistance, please email: [email protected]